Question

At an airport, luggage is unloaded from a plane into threecars of a luggage carrier. The acceleration of the carrier is 0.12m/s^{2}, and friction is n

Other
ANSWERED
asked 2021-03-30
At an airport, luggage is unloaded from a plane into threecars of a luggage carrier. The acceleration of the carrier is \(\displaystyle{0.12}\frac{{m}}{{s}^{{{2}}}}\), and friction is negligible. The coupling bars havenegligible mass. By how much would the tension in each of thecoupling bars A,B, and C change if 39kg of luggage were removedfrom car 2 and placed in (a) car 1 and (b) car 3? If the tensionchanges, specify whether it increases or decreases.

Answers (1)

2021-04-01
ension in coulping bars A does not changeswhen lugguage is placed in car1
tension in coulping bars B changes when lugguage is placed in car1
tension in coulping bars C changes when lugguage is placed in car1
tension in coulping bars ( A or B orC ) does not changes when lugguage is placed in car3
0
 
Best answer

expert advice

Need a better answer?

Relevant Questions

asked 2021-04-25
A wagon with two boxes of Gold, having total mass 300 kg, is cutloose from the hoses by an outlaw when the wagon is at rest 50m upa 6.0 degree slope. The outlaw plans to have the wagon roll downthe slope and across the level ground, and then fall into thecanyon where his confederates wait. But in a tree 40m from thecanyon edge wait the Lone Ranger (mass 75.0kg) and Tonto (mass60.0kg). They drop vertically into the wagon as it passes beneaththem. a) if they require 5.0 s to grab the gold and jump out, willthey make it before the wagon goes over the edge? b) When the twoheroes drop into the wagon, is the kinetic energy of the system ofthe heroes plus the wagon conserved? If not, does it increase ordecrease and by how much?
asked 2021-02-19
An airplane propeller is 2.08 m in length (from tip to tip) and has a mass of 117 kg. When the airpline's engine is first started, it applies a constant torque of \(\displaystyle{1950}\ {N}\cdot{m}\) to the propeller, which starts from rest.
a) What is the angular acceleration of the propeller? Model the propeller as a slender rod.
b) What is the propeller's angular speed after making 5.00 revolutions?
c) How much work is done by the engine during the first 5.00 revolutions?
e) What is the instantaneous power output of the motor at the instant that the propeller has turne through 5.00 revolutions?
asked 2021-04-21
Car 1 has a mass of m1 = 65 ❝ 103 kg and moves at a velocity of v01 = +0.81 m/s. Car 2, with a mass of m2 = 92 ❝ 103 kg and a velocity of v02 = +1.2 m/s, overtakes car 1 and couples to it. Neglect the effects of friction in your answer.
(a) Determine the velocity of their center of mass before the collision m/s
(b) Determine the velocity of their center of mass after the collision m/s
(c) Should your answer in part (b) be less than, greater than, or equal to the common velocity vf of the two coupled cars after the collision? less than greater than equal to
asked 2021-02-19
A 10 kg objectexperiences a horizontal force which causes it to accelerate at 5 \(\displaystyle\frac{{m}}{{s}^{{2}}}\), moving it a distance of 20 m, horizontally.How much work is done by the force?
A ball is connected to a rope and swung around in uniform circular motion.The tension in the rope is measured at 10 N and the radius of thecircle is 1 m. How much work is done in one revolution around the circle?
A 10 kg weight issuspended in the air by a strong cable. How much work is done, perunit time, in suspending the weight?
A 5 kg block is moved up a 30 degree incline by a force of 50 N, parallel to the incline. The coefficient of kinetic friction between the block and the incline is .25. How much work is done by the 50 N force in moving the block a distance of 10 meters? What is the total workdone on the block over the same distance?
What is the kinetic energy of a 2 kg ball that travels a distance of 50 metersin 5 seconds?
A ball is thrown vertically with a velocity of 25 m/s. How high does it go? What is its velocity when it reaches a height of 25 m?
A ball with enough speed can complete a vertical loop. With what speed must the ballenter the loop to complete a 2 m loop? (Keep in mind that the velocity of the ball is not constant throughout the loop).
asked 2021-04-13
As depicted in the applet, Albertine finds herself in a very odd contraption. She sits in a reclining chair, in front of a large, compressed spring. The spring is compressed 5.00 m from its equilibrium position, and a glass sits 19.8m from her outstretched foot.
a)Assuming that Albertine's mass is 60.0kg , what is \(\displaystyle\mu_{{k}}\), the coefficient of kinetic friction between the chair and the waxed floor? Use \(\displaystyle{g}={9.80}\frac{{m}}{{s}^{{2}}}\) for the magnitude of the acceleration due to gravity. Assume that the value of k found in Part A has three significant figures. Note that if you did not assume that k has three significant figures, it would be impossible to get three significant figures for \(\displaystyle\mu_{{k}}\), since the length scale along the bottom of the applet does not allow you to measure distances to that accuracy with different values of k.
asked 2021-03-24
A 1300-kg car coasts on a horizontal road, with a speed of18m/s. After crossing an unpaved sandy stretch of road 30.0 mlong, its speed decreases to 15m/s. If the sandy portion ofthe road had been only 15.0 m long, would the car's speed havedecreasedby 1.5 m/s, more than 1.5 m/s, or less than 1.5m/s?Explain. Calculate the change in speed in that case.
asked 2021-05-04
Assume that a 1.00-kg ball is thrown solely by the action of the forearm, which rotates about the elbow joint under the action of the triceps muscle. The ball is accelerated uniformly from rest to 10.0 m/s in 0.350 s, at which point it is released. Calculate (a) the angular acceleration of the arm, and (b) the force required of the triceps muscle. Assume that the forearm has a mass of 3.70 kg and rotates like a uniform rod about an axis at its end.
asked 2021-03-22
A box is sliding with a speed of 4.50 m/s on a horizontal surface when, at point P, it encounters a rough section. On the rough section, the coefficient of friction is not constant but starts at .100 at P and increases linerly with distance past P, reaching a value of .600 at 12.5 m past point P. (a) Use the work energy theorem to find how far this box slides before stopping. (b) What is the coefficient of friction at the stopping point? (c) How far would the box have slid iff the friciton coefficient didn't increase, but instead had the constant value of .1?
asked 2021-05-06
A spring is mounted vertically on the floor. The mass of the spring is negligible. A certain object is placed on the spring to compress it. When the object is pushed further down by just a bit and then released, one up/down oscillation cycle occurs in 0.250 s. However, when the object is pushed down by 5.00 X 10^-2 m to point P and then released, the object flies entirely off the spring. To what height above point P does the object rise in the absence of air resistance?
asked 2021-02-27
An alpha particle (a He nucleus, containing two protons and two neutrons and having a mass of \(\displaystyle{6.64}\cdot{10}^{{-{27}}}\) kg) traveling horizontally at 35.6 km/s enters a uniform, vertical, 1.10 T magnetic field.
A) What is the diameter of the path followed by this alpha particle?
B) What effect does the magnetic field have on the speed of the particle?
C) What are the magnitude of the acceleration of the alpha particle while it is in the magnetic field?
D) What are the direction of the acceleration of the alpha particle while it is in the magnetic field?

You might be interested in

...