Question

A circular tabletop is to be cut from a rectangular piece of wood that measures 1.20 m by 1.80 m. What is the radius of the largest table top that could be cut? Justify your answer. Include a sketch.

Circles
ANSWERED
asked 2021-02-23
A circular tabletop is to be cut from a rectangular piece of wood that measures 1.20 m by 1.80 m. What is the radius of the largest table top that could be cut? Justify your answer. Include a sketch.

Answers (1)

2021-02-24
The largest circle that can be cut from the rectangular piece of wood would have a diameter equal to the shorter dimension which is 1.20 m so as the circle fit inside. Hence, the radius is 1.20/2=0.60 m. [Pic]
0
 
Best answer

expert advice

Need a better answer?

Relevant Questions

asked 2021-05-08
Find the dimensions of the rectangle of largest area that can be inscribed in a circle of radius .
asked 2021-02-19
A 10 kg objectexperiences a horizontal force which causes it to accelerate at 5 \(\displaystyle\frac{{m}}{{s}^{{2}}}\), moving it a distance of 20 m, horizontally.How much work is done by the force?
A ball is connected to a rope and swung around in uniform circular motion.The tension in the rope is measured at 10 N and the radius of thecircle is 1 m. How much work is done in one revolution around the circle?
A 10 kg weight issuspended in the air by a strong cable. How much work is done, perunit time, in suspending the weight?
A 5 kg block is moved up a 30 degree incline by a force of 50 N, parallel to the incline. The coefficient of kinetic friction between the block and the incline is .25. How much work is done by the 50 N force in moving the block a distance of 10 meters? What is the total workdone on the block over the same distance?
What is the kinetic energy of a 2 kg ball that travels a distance of 50 metersin 5 seconds?
A ball is thrown vertically with a velocity of 25 m/s. How high does it go? What is its velocity when it reaches a height of 25 m?
A ball with enough speed can complete a vertical loop. With what speed must the ballenter the loop to complete a 2 m loop? (Keep in mind that the velocity of the ball is not constant throughout the loop).
asked 2021-05-28
Assuming that the radius of your disk is one unit, what is its exact circumference?
asked 2021-05-04

When a gas is taken from a to c along the curved path in the figure (Figure 1) , the work done by the gas is W = -40 J and the heat added to the gas is Q = -140 J . Along path abc, the work done by the gas is W = -50 J . (That is, 50 J of work is done on the gas.)
I keep on missing Part D. The answer for part D is not -150,150,-155,108,105( was close but it said not quite check calculations)
Part A
What is Q for path abc?
Express your answer to two significant figures and include the appropriate units.
Part B
f Pc=1/2Pb, what is W for path cda?
Express your answer to two significant figures and include the appropriate units.
Part C
What is Q for path cda?
Express your answer to two significant figures and include the appropriate units.
Part D
What is Ua?Uc?
Express your answer to two significant figures and include the appropriate units.
Part E
If Ud?Uc=42J, what is Q for path da?
Express your answer to two significant figures and include the appropriate units.
...